Global Fog

Global fog is used to simulate fog effects in outdoor environments in video games. In addition to fog representation in video games, it can also be used to hide the model outside the camera's far clipping plane to improve rendering performance.

Check Scene in the Hierarchy panel, then check the Enabled property in the Fog component of the Inspector panel to enable global fog.

image

Types of Global Fog

The type of global fog depend on the result of the calculation of Camera and Model Vertices, which is called the Fog Blend Factor. The fog blend factor determines how the fog colors and model colors are blended, resulting in a different global fog effect. Currently there are four fog types including LINEAR, EXP, EXP_SQUARED, and LAYERED.

Linear

Property Description
Enabled Whether to enable the global fog
FogColor The color of the global fog
Type The type of the global fog
FogStart The starting position of the fog effect
FogEnd The end position of the fog effect

The fog blend factor of Linear Fog is calculated by the formula: f = (FogEnd - Cam_dis) / (FogEnd - FogStart)

  • When Cam_dis = FogEnd, i.e., the distance between the camera and the model vertex is equal to FogEnd, the blend factor is calculated as 0, and the object is fully fogged.

  • When Cam_dis = FogStart, i.e. the distance between the camera and the model vertex is equal to FogStart, the blend factor is calculated as 1, and the object is not affected by fogging.

To increase the density of Linear Fog when the distance between the camera and the model vertex is fixed, there are two ways:

  1. fix the value of FogStart and decrease the value of FogEnd.
  2. Decrease the value of FogStart and fix the value of FogEnd.

To adjust the fog effect to the right consistency, it is best to adjust both the FogStart and FogEnd properties appropriately. An example effect of Linear Fog is shown below:

image

Exponential and Exponential Squared

exp-properties

Property Description
Enabled Whether to enable the global fog
FogColor The color of the global fog
Type The type of the global fog
FogDensity The fog density, in the range 0 ~ 1
FogAtten Fog attenuation coefficient

The fog blend factor for Exponential Fog is calculated as: f = e^(-distance * fogDensity)

The fog blend factor for Exponential Squared Fog is calculated as: f = e^(-distance * fogDensity)²

Developers can use FogDensity and FogAtten to adjust the density of global fog at different locations.

An example effect of Exponential Fog is shown below.

image

Layered

Layered Fog is parallel to the horizontal plane and has a specific height. The height of the fog can be determined by setting the top of the Layered Fog at any position in the vertical direction of the scene world coordinate system.

layered-properties

Property Description
Enabled Whether to enable the global fog
FogColor The color of the global fog
Type The fog type of the global fog
FogAtten Fog attenuation coefficient
FogTop The position of the model vertices in the vertical direction of the world coordinate system, below which all vertices will be affected by the fog effect
FogRange The range of the fog effect

The fog calculation of Layered Fog is a bit more complicated than the previous three fog types, as it introduces the concept of FogTop and also requires distance calculation in the x-z plane.

Layered Fog is more common in reality, with towering mountains and buildings. If it is used wisely, it is believed to have a good effect on scene presentation, but at the same time, the computation will be increased, developers can decide according to their needs.

An example of Layered Fog:

image

results matching ""

    No results matching ""